sanding and polishing machines often fail in daily use. In addition to timely troubleshooting, daily inspection and maintenance are also essential. As an expensive product, wood polish spray machine is not a small object for individuals or companies. , do not cause its damage due to temporary negligence.
The first inspection is 4 hours after the new machine is used or the new one is replaced; the second inspection is 1 day after the previous inspection; the third inspection is 3 days after the previous inspection; the fourth inspection interval is the previous inspection 5 days after the examination; the fifth examination interval is 7 days after the previous examination; subsequent examinations every other week. When replacing the belt of the wood sanding polishing machine, pay attention to it. If one of the belts on the same pulley is broken and needs to be replaced, be sure to replace the other belts hanging on the same pulley at the same time.
In order to achieve the correct distribution of the grinding volume of the sander, the sander must be adjusted. The adjustment of the sander generally adopts the principle of the lower frame, that is, first adjust the lower frame, and then adjust the upper frame based on the lower frame. It is difficult to adjust the lower frame, the upper frame must be raised, and a fine adjustment with a ruler and a bar level is required, which takes a long time. Therefore, after adjusting the lower rack, the user should keep the lower rack state and make necessary marks, which will greatly save time. Usually, before the machine leaves the factory, the basic adjustment has been completed, and the debugging personnel can make fine-tuning on the spot. However, when the user uses it for a period of time or replaces the main components, a wide range of adjustments will be made. Therefore, maintenance personnel must master the adjustment method. Inquiry Kisinhon sanding machine supplier.
The plate produces a line similar to a dashed-dotted line. This point is generally raised. The reason is that when the abrasive belt falls off due to its own quality or is scratched by the hard object of the sanding board, a raised dot-dash line appears. If the abrasive belt is fine sand, the abrasive belt must be scrapped. The sander will also find other surface defects during the sanding process, such as local roughness and local spots on the surface of the board, which are the quality problems of the board itself. Most of the sanded boards can feel different roughness in the forward and reverse directions by hand. This is because the fine fibers on the surface of the sanded board are only ironed during the sanding process, and are not removed. Change the sander process to start. In the six-sand rack or eight-sand rack, the rotation direction of the last second belt can generally be changed to improve the difference between the smooth and the negative.
English 
